V&T E5-H Series User Manual page 19

E5−H High Performance Universal Inverter User Manual
2−7, and then press the lower part of the upper cover in direction 2 as shown in Figure 2−7, until the
"crack" sound is heard.
Mounting of lower cover
Insert the upper claw grab the lower cover into the groove of the upper cover, as shown in position
1 of Figure 2−8, and then press the lower part of the lower cover in direction 2 of Figure 2−8, until
the "crack" sound is heard. Now, tighten the cover screws.
Figure 2−7 Mounting of upper cover Figure 2−8 Mounting of lower cover
Mounting of operation panel
Please refer to 2.3.1 Removal and mounting of operation panel.
2.3.3 Removal and Mounting of Covers of E5−H−4T11G~E5−H−4T75G and Above Power
Class Inverter with Sheet−metal Enclosure
Removal of operation panel
Please refer to 2.3.1 Removal and mounting of operation panel.
Removal of cover
Remove the mounting screws on the lower part of the cover, lift the cover in direction 1 as shown in
Figure 2−9, and then take out the cover in direction 2.
Mounting of cover
After connecting the cables of main circuit terminals and control circuit terminals, cramp the cover in
direction 1 as shown in Figure 2−10, press down the cover in direction 2 and then tighten the cover
screws.
12 Chapter 2 Inverter Installation