Default Setup - Intermec EasyCoder PC4 Programmer's Reference Manual

Chapter 3 — Setting Up the Printer

Default Setup

Default Printer Settings
Parameter
Error/status character
Density
Character set
Top of form backup
Media feed adjust
Label gap sensor
Character
substitution
Form length
Label width
Reference point
Print speed
Reply character
Error handling
Windows mode
Serial port
Print direction
Default Printhead Settings
Printhead Resolution
203.2 dpi printheads
300 dpi printheads
18
This table lists the default settings on the PC4 or PF8 printers.
Command Default Setting
XOFF/XON-handling
eR0,0
10
D10
8 bits, code page 0, country code 001
I8,0,001
Enabled
JF
136 dots at 203.2 dpi
J136
J204
204 dots at 300 dpi
LTS, TT mode, reverse gap, and cutter disabled.
ON
No substitution
oR
Continuous mode, print gap 24 dots
Q24,0
832 dots at 203.2 dpi
q832
q1208
1208 dots at 300 dpi
X:000, Y:000
R000,000
76 mm/sec (3 inches/sec)
S3
None
UC0
Error reporting disabled
UN
Disabled
WN
9600 baud, no parity, 8 data bits, 1 stop bit
Y96,N,8,1
Start printing at top of image buffer
ZT
Measures
203.2 dpi (8 dots/mm) in both directions
300 dpi (11.8 dots/mm) across the media path
304.8 dpi (12 dots/mm) along the media path
ESim for the PC4 and PF8 Printer Programmer's Reference Manual