D - Remaining Labels; Default - Restore Factory Defaults; Ee - Immediate Error Report - Intermec EasyCoder PC4 Programmer's Reference Manual

Chapter 7 — Commands

^D - Remaining Labels

Purpose:
Syntax:
Remarks:

^default - Restore Factory Defaults

Purpose:
Syntax:
Remark:

^ee - Immediate Error Report

Purpose:
Syntax:
Remarks:
128
This high priority command makes the printer return the
number of labels remaining to be printed in a batch print job.
^D
The reply at command US is by default Pnnnn<CR><LF>, where
is the number of remaining labels.
This command can only be sent via the RS-232 or USB ports.
Example:
This example renders a box and orders the printer to print 4
copies. At command ^A, the printing is paused and interrogated
for remaining number of labels. Printing is continued again at
command ^C.
X0,0,10,20,40
P4
^A
^D
^C
This command sets all parameters back to the factory default.
^default
This command returns the printer to its default setup when
necessary; for example, prior to updating firmware. See
Setup" on page 18
After sending this command, wait at least two seconds before
sending any further commands to ensure the printer has fully
restarted.
This command makes the printer report error and status
immediately via the RS-232 or USB port.
^ee
After the command is sent into printer via the RS-232 or USB
interface, the printer returns an error and status report on the
serial port once it when reaches a state of normal-command-
input or error-waiting-recovering.
ESim for the PC4 and PF8 Printer Programmer's Reference Manual
for the default value of setup parameters.
"Default