Uc - Command Reply Accept Character Control - Intermec EasyCoder PC4 Programmer's Reference Manual

Chapter 7 — Commands

UC - Command Reply Accept Character Control

Purpose:
Syntax:
Remarks:
112
An example of a PF8 printer configuration label.
This command specifies a prompt acknowledge character which
the printer returns on the RS-232 or USB channel to the host
after each command execution with no error reply before
proceeding with the next command.
UCp
1
.
UC Command Parameter Descriptions
Parameter Description
p Specifies the desired reply character by its ASCII
1
decimal value (0-255).
If p
or the value is 0, there is no Command Reply
Accept character (default).
Default is no Command Reply Accept Character (command
UC0).
ESim for the PC4 and PF8 Printer Programmer's Reference Manual
is anything other than numerical characters
1