Default Setup - Intermec EasyCoder C4 Reference Manual

Chapter 3—Setting Up the Printer

Default Setup

Parameter
Error/Status Char.
Density
Character Set
Top of Form backup
Media feed adjust
Label Gap Sensor
Label Taken Sensor
Ribbon End Sensor
Cutter (option)
Char. substitution
Form Length
Label Width
Reference Point
Reply Character
Print Speed
Error Handling
Windows Mode
Serial Port
Print Direction
Printhead Resolution Measures
203.2 dpi printheads
300 dpi printheads
The setup will be reset to default values if...
• the printer's fi rmware is upgraded using a fi rmware cartridge,
• or the Feed key is pressed more than 3 seconds in the Dump Mode.
14 Intermec EasyCoder ESim v4.00—Programmer's Reference Manual
Command Default Setting
eR0,0 XOFF/XON-handling
eR
10
D
8 bits, code page 0, country code 001
I
JB/JF Disabled/Enabled
136 dots (at 203.2 dpi)
j
204 dots (at 300 dpi)
O Normal (blockage of light = label)
O Enabled
O Enabled (not in pure DT printers)
O Disabled
No substitution
oR
Length 1200 dots, gap 24 dots at 203.2 dpi
Q
Length 1200 dots, gap 24 dots at 300 dpi
832 dots (at 203.2 dpi)
q
1208 dots (at 300 dpi)
R X:000;Y000
UC none
S 50 mm/sec. (2 inches/sec.)
UN/US Disabled
W Disabled
9600 baud, no parity, 8 data bits, 1 stop bit
Y
ZT (Start printing at top of image buffer)
Z
203.2 dpi (8 dots/mm) in both directions
300 dpi (11.81 dots/mm) across the media path
304.8 dpi (12 dots/mm) along the media path