Intermec EasyCoder PC4 Programmer's Reference Manual page 66

ESim for the PC4 and PF8 Printer Programmer's Reference Manual
b - EAN/UCC Command Parameter Description (continued)
Parameter Description
M Manually controlled Pipe character:
Separator between data of linear and
two-dimensional composite part. Use this parameter
only in exceptional case.
Limit is any printable character.
Default is M|.
Data |Data The data area represents a string data field
1 2
surrounded by quotation-marks. Max data length is
relative chosen model type and data mode.
Invocation code in string follows the rules for
selectable Code 128,
on page
allowed in composite code.
Data String of primary data to linear component.
1
Limit is 48 digit maximum.
| Data separator pipe character.
Data string of secondary data to two-dimensional
2
composite data.
Limit is all characters are in ISO 646.
Errors occur if:
• data is not suitable to optional parameters => error 01
(syntax error).
• data is too long or out of range => error 03
(at length error).
• data does not fit in area specified => error 50.
Chapter 7 — Commands
see"B - Standard Bar Codes"
42. FNC2, FNC3, and FNC4 are not
51