Ui - Enable Prompts/Code Page Inquiry; Um - Code Page And Memory - Intermec EasyCoder PC4 Programmer's Reference Manual

UI - Enable Prompts/Code Page Inquiry

Purpose:
Syntax:
Remarks:

UM - Code Page and Memory

Syntax:
ESim for the PC4 and PF8 Printer Programmer's Reference Manual
The UG command is executed directly without appending a
Linefeed.
This command causes the printer to enable prompts to be sent to
the host and to send the currently selected code page to the host
through the RS-232 or USB port.
UI
The printer sends information on the currently selected code
page back to the host in the following formats:
UIp ,p ,p
1 2 3
.
UI Command Parameter Descriptions
Parameter Description
p Number of data bits.
1
p Code page.
2
p Country code.
3
The keyboard display unit automatically sends this command
each time power is applied. The UI command is disabled by
removing power from the printer for 60 seconds.
Also see "I - Character Selection" on page 81
Configuration (General)" on page
Example:
This example enables prompts from the host and returns the
current code page.
UI
UI80,001
This command causes the printer to send the currently selected
code page and memory status to the host through the RS-232 or
USB port.
UM
Chapter 7 — Commands
and "U- Print
111.
115