J - Media Feed Adjustment - Intermec EasyCoder PC4 Programmer's Reference Manual

Chapter 7 — Commands

j - Media Feed Adjustment

Purpose:
Syntax:
Remarks:
86
This command makes it possible to set the media feed for tear-off
(straight-through), peel-off (self-strip), or cut-off operation.
jp
1
.
j Command Parameter Descriptions
Parameter Description
p Length of media feed after printing in dots
1
(0-160).
Recommended values at 203.2 dpi (8 dots/mm):
• Tear-off (straight-through) operation: 136
• Peel-off (self-strip) operation: 110
Recommended values at 300 dpi
(11.81 dots/mm):
• Tear-off (straight-through) operation: 204
• Peel-off (self-strip) operation: 165
When using peel-off operation, the labels should remain slightly
stuck to the liner (backing paper) so they do not fall off but can
still can be easily removed.
In tear-off operation, the j command adjusts the media feed so
that the perforation between tags or gap between labels is aligned
with the tear bar.
Do not use extremely small or large values for the j command
as such values may cause the printer to feed or pull back the
media continuously.
The extra media feed set by the j command can be enabled or
disabled using JF and JB "Top of Form Backup" commands. By
default, "Top of Form Backup" is enabled.
ESim for the PC4 and PF8 Printer Programmer's Reference Manual
(default)
(default)