F - Cut Position - Intermec EasyCoder PC4 Programmer's Reference Manual

Remarks:

f - Cut Position

Purpose:
Syntax:
ESim for the PC4 and PF8 Printer Programmer's Reference Manual
Exception of output: Error 07 "Out of media or ribbon," is added
after 07 with P or R
labels:
Output at error media action (mode 0):
<NAK>07Pnnn<XOFF>
Output at error ribbon action (mode 0):
<NAK>07Rnnn<XOFF>
Output at error recovery:
<XON>
Mode 1, 2, and 6 changes the output in a similar way.
All parameters are saved in flash memory. If more than one error
occurs at the same time, there is an output for each error
recovery, like
<p >00<CRLF>
1
on error handling, "Error Handling Principles" on page 148
Appendix A.
Example:
Manual
Command Action
US
eRC,2,Q
Open cover C11<CRLF> Manual action generates
Close cover Q00<CRLF> Manual recovery on error
This command is used to adjust the cutting position along the y-
axis in relation to the media according to other characteristics of
individual printers and batches of media.
fp
1
Chapter 7 — Commands
, where = number of remaining
on mode 2. For more information
Reply Comments
<ACK> Enables error reporting.
Reply error with character
"C" and error NN and at
recovery with character
"Q".
error 11.
11.
in
71