Udc - Memory Cartridge Information (Pc4 Only) - Intermec EasyCoder PC4 Programmer's Reference Manual

UDC - Memory Cartridge Information (PC4 only)

Purpose:
Syntax:
Remarks:
ESim for the PC4 and PF8 Printer Programmer's Reference Manual
Parameter p saves in Flash.
1
If command UC is activated, it replaces the <ACK> character at
the end of command US and P.
If an error occurs and error report is activated, the error message
is sent instead.
Example:
The table below shows an example of the UC command with the
a reply.
Command
UC062
US
X50,200,5,400,20
P
This command checks an inserted memory cartridge and returns
information on its content on the RS-232 or USB channel.
UDC
This command checks the memory cartridge for the following
information and returns one of the following alternatives listed in
the table below.
Memory Cartridge Commands and Explanations
Command
NA
000
001-004
Chapter 7 — Commands
Reply Explanation
> Set Command Reply Accept
character to ">".
> Reply error.
> Draw a box.
> Print box and reply ">" at ready.
Explanation
Cartridge not detected.
Cartridge detected, but no relevant
information is found.
Cartridge detected. Followed by one to four
lines of information on detected firmware,
and/or Asian fonts.
113