Further Settings; Seat And Back Upholstery - Otto Bock Start M1 Instructions For Use Manual

Use
3) Guide the other end around the foot support holder (see fig. 12, item 1).
4) Adjust the length and fasten the hook-and-loop closure (see fig. 13).
Removing the calf strap
1) Open all hook-and-loop closures.
2) Remove the calf strap from the frame tube.
11
13

7.3.1 Further settings

Further adjustments may be made only by qualified personnel.

7.4 Seat and back upholstery

WARNING
Seat cushions and back support pads may ignite
Burns due to user error
► The seat and back support upholstery as well as seat cushions, padding and covers fulfil the normative
requirements for flame resistance. However, they may still ignite if fire is handled improperly or negligently.
► Keep away from all ignition sources, especially lit cigarettes.
CAUTION
Wear of the seat and back upholstery
Loss of functionality due to prohibited continued use
► Have the seat and back upholstery replaced immediately in case of damage.
The product is equipped with seat and back upholstery. Hook-and-loop fasteners on the seat upholstery are used
to attach the seat cushion. The seat cushion ensures pressure relief during use of the wheelchair.
The seat upholstery and back support upholstery/back support pad can be removed from the wheelchair for clean­
ing.
Removing the seat upholstery
1) Remove the Phillips head screws on each side (see fig. 14, item 1).
16
12
Start M1