Connecting A Terminal To The Cisco Asr Series 1000 Route Processor Console Port - Cisco ASR 1000 series Hardware Installation Manual

Connecting a Terminal to the Cisco ASR Series 1000 Route Processor Console Port

Remove the tape from the circuit-breaker switch handle and move the circuit-breaker handle to the
Step 10
on position, if you taped the circuit breaker.
Step 11 Switch the On/Off circuit breaker switch to the On (|) position.
This completes the procedure for connecting the –48 VDC power supply in the Cisco ASR 1004 Router.
Connecting a Terminal to the Cisco ASR Series 1000 Route
Processor Console Port
The Cisco ASR 1004 route processor has an asynchronous serial (EIA/TIA-232) RJ-45 console port
labeled CON on its front panel. You can connect this port to most types of video terminals through use
of the console cable kit that is included with your Cisco ASR 1004 Router. The console cable kit
contains:
•
•
A crossover cable reverses pin connections from one end to the other. In other words, it connects pin 1
(at one end) to pin 8 (at the other end), pin 2 to pin 7, pin 3 to pin 6, and so on. You can identify a
crossover cable by comparing the two modular ends of the cable. Hold the cable ends in your hand,
side-by-side, with the tabs at the back. Ensure that the wire connected to the outside (left) pin of the left
plug (pin 1) is the same color as the wire connected to the outside (right) pin of the right plug (pin 8).
Use the following procedure to connect a video terminal to the console port on a route processor.
Note Each Cisco ASR 1000 Series Route Processor 1 must have a console port connection (typically to a
terminal server) if you are running a redundant configuration in the chassis.
Figure 7-21
Figure 7-21
1
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
7-30
One RJ-45 to RJ-45 crossover cable
One RJ-45 to DB-9 (female) adapter
shows the route processor console port.
Cisco ASR 1004 Router ASR 1000 Series Route Processor Console Port
CR IT
MA J
ACT V
PW R
MIN
STB Y
STA T
P1
AS R1 00 0-R
CON port connection
Chapter 7
1
OS
SPA -4XO C3-P
SPA -4XO C3-P OS
LIN K CO N
ERN ET
MGM T ETH
HD CA RR IER
BIT S
USB
DF
DIS K
1
0
2 AUX port connection
Cisco ASR 1004 Router Overview and Installation
2
SPA -4XO C3-P OS
AUX
OL-13208-11