Removing The Valves - Husqvarna FE 350 2016 Repair Manual

18.4.21

Removing the valves

-
Remove screw plugs
Screw appropriate screw @ into the cam lever shaft.
Hold cam levers
Info
If the cam levers will continue to be used, note down
their installation position.
Take the shims out of the valve spring retainers and lay them
to one side according to their normal built-in position.
Pre-tension the valve spring using the special tool.
Valve spring mounter (59029019000)
Insert for valve spring lever (77229060000)
Remove the valve keys and unload the valve spring.
Remove the valve spring retainer and valve springs.
Pull the valve down out of the valve guide.
Remove valve stem seal
I
Valve stem seals plier (77229010000)
Remove valve spring seat
302712-10
Mark the valves according to their normal built-in position.
Info
Place the valves into a box according to the installa­
tion position and label the box.
300117-10
O
with the O-ring.
fD
and remove the cam lever shaft.
(a p. 360)
(a
C,
with the special tool.
(a p. 363)
0.
18 ENGINE
p. 365)
41
211