Husqvarna FE 350 2016 Repair Manual page 158

16 BRAKE SYSTEM
156
.>-------400379-10
(FE 350 SUS)
-
Disconnect the bleeding device. Remove the bleeder
cover.
-
Add brake fluid to level (!).
I
Guideline
Level (!)
I
Brake fluid DOT 4 (ilel p. 352)
-
Position the cover with the membrane. Mount and tighten
the screws.
Info
Clean up overflowed or spilled brake fluid immedi­
ately with water.
-
Check the hand brake lever for a firm pressure point.
-
Move the brake fluid reservoir mounted on the handlebar
to a horizontal position.
-
Cover painted parts.
O.
-
Remove screws
8
-
Take off cover with the membrane.
-
Draw the old brake fluid out of the brake fluid reservoir
using a syringe and fill with fresh brake fluid.
Syringe (50329050000)
Brake fluid DOT 4 (ilel p. 352)
@).
-
Mount bleeder cover
I
Bleeder cover (00029013005)
-
Connect the bleeding device.
I
Bleeding device (00029013100)
C,.
-
Open shut-off valve
• Info
I
Follow the operating instructions of the bleeding
device.
-
Ensure that the filling pressure is set on pressure
gauge 6). Correct the filling pressure on pressure
regulator G) if necessary.
I
Guideline
Filling pressure
I
5 mm (0.2 in)
(ilel p. 358)
(ilel p. 356)
(� p. 356)
I
2 ... 2.5 bar (29 ... 36 psi)