Husqvarna FE 350 2016 Repair Manual page 206

18 ENGINE
204
-
Press in the new crank pin
✓ Oil hole
X If the oil holes are not correctly aligned, the conrod bear­
-
Blow compressed air through the oil channel to check that it
is clear.
302912-10
-
Mount the new connecting rod
-
Position special tool
-
Insert the crank web with connecting rod and bearing. Posi­
tion the second crank web.
-
Position special tool @ with the heel pointing down.
I Crankshaft pressing tool insert (77229008000)
Press in the upper crank web as far as possible.
-
Take the crankshaft out of the special tool and check that the
connecting rod can move freely.
-
Measure the axial play between the connecting rod and the
,--@)
crank webs with special tool
I Feeler gauge (59029041100)
308662-10
Finishing work
-
Check the crankshaft run-out at the bearing pin.
CD
6)
is aligned with oil hole G).
ing will not be supplied with oil.
Info
Thoroughly oil the bearing
(D
on the press.
Crankshaft pressing tool (75029047000)
Crankshaft pressing tool insert (77229008000)
Info
The press mandrel must be positioned over the crank
pin.
@).
Connecting rod - axial play
of lower conrod bearing
If the specification is not reached:
-
Correct it so the dimension is equal to the specified
value.
as far as possible.
C,.
0.
(� p. 362)
(� p. 363)
(� p. 363)
(� p. 360)
0.20 ... 0.45 mm (0.0079 ...
0.0177 in)
(� p. 205)
..