Removing The Valves - Husqvarna FE 350 2015 Repair Manual

ENGINE
18
18.4.21

Removing the valves

••
-
Pl//
:E-V1
•
-
Take off the camshafts and clean the parts.
-
Remove screw plugs
-
Screw appropriate screw
-
Hold cam levers
• Info
I
If the cam levers will continue to be used, note down their installation posi­
tion.
-
Take the shims out of the valve spring retainers and lay them to one side accord­
ing to their normal built-in position.
-
Pre-tension the valve spring using the special tool.
Valve spring mounter (59029019000)
Insert for valve spring lever (77229060000)
Remove the valve keys and unload the valve spring.
-
Remove the valve spring retainer and valve springs.
-
Pull the valve down out of the valve guide.
-
Remove valve stem seal
I
Pliers for valve stem seals (77229010000)
-
Remove valve spring seat
302712-10
-
Mark the valves according to their normal built-in position.
• Info
I
Place the valves into a box according to the installation position and label
the box .
300117-10
O
with the O-ring.
8
into the cam lever shaft.
8
and remove the cam lever shaft.
(lllll p. 290)
(�
8
with the special tool.
(�
0.
p. 295)
p. 293)
163