Changing The Rear Brake Disc - Husqvarna FE 350 2016 Repair Manual

14 WHEELS
14.8.3
128

Changing the rear brake disc

Info
If the brake discs are changed, the brake linings must also be changed.
-
Position chain adjuster 6) . Mount nut
tighten it yet.
-
Make sure that chain adjusters 6) are fitted correctly on
0-
adjusting screws
-
Check the chain tension.
C,.
-
Tighten nut
Guideline
Info
The wide adjustment range of the chain adjusters
(32 mm (1.26 in)) enables different secondary
ratios with the same chain length.
Chain adjusters 6) can be turned by 180
-
Operate the foot brake lever repeatedly until the brake
linings are in contact with the brake disc and there is a
pressure point.
Finishing work
-
Remove the motorcycle from the lift stand.
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the rear wheel. (!l;!l
Main work
(FE EU/AU, FE 350 US)
O.
-
Remove screws
-
Clean the contact surface of the brake disc.
-
Position the new brake disc with the label facing outward.
-
Mount and tighten screws
Guideline
Screw, rear M6
brake disc
(FE 350 SUS)
O.
-
Remove screws
-
Clean the contact surface of the brake disc.
-
Position the new brake disc with the label facing outward.
-
Mount and tighten screws
Guideline
Screw, rear M6
brake disc
C,,
but do not
(!l;!l p. 129)
M20x1 .5 80 Nm (59 lbf ft)
°
(!!ll p. 13)
(!l;!l p. 13)
p. 125)
Take off the brake disc.
O.
14 Nm (10.3 lbf ft)
Loctite
Take off the brake disc.
O.
14 Nm (10.3 lbf ft)
Loctite
.
®
243
™
® 243
™