Husqvarna FE 350 2016 Repair Manual page 35

Table of Contents

Advertisement

201715-10
e
I
-
Sand the edges of the sliding bushings with 600 grit sandpa­
per; then clean and grease the bushings.
I
Fork oil (SAE 4) (48601166S1)
-
Push on lower sliding bushing
-
Mount upper sliding bushing Q).
Info
Without using a tool, pull the stack slightly apart by
hand.
-
Warm up the outer tube in area
ing.
/
I
Guideline
50 °C (122 °F)
-
Slide the outer tube onto the inner tube.
-
Hold the lower sliding bushing with the longer side of the
special tool.
I
Mounting tool (T14040S)
-
Press the sliding bushing all the way into the outer tube.
-
Position the support ring.
-
Hold the seal ring with the shorter side of the special tool.
I
Mounting tool (T14040S)
-
Press the seal ring and support ring all the way into the outer
tube.
-
Mount lock ring@.
Info
The lock ring must engage audibly.
6 FORK, TRIPLE CLAMP
(llill
p. 352)
0.
f)
of the lower sliding bush-
(llill
p. 370)
(llill
p. 370)
33

Advertisement

Table of Contents
loading

Table of Contents