Changing The Steering Head Bearing - Husqvarna FE 350 2016 Repair Manual

6.26

Changing the steering head bearing

Main work
-
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bear­
ing.
If there is detectable play:
-
Adjust the steering head bearing play.
-
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the
entire steering range. There should be no detectable detent
positions.
If detent positions are detected:
-
Adjust the steering head bearing play.
-
Check the steering head bearing and replace if neces-
sary.
Finishing work
-
Remove the motorcycle from the lift stand.
Preparatory work
-
Remove the headlight mask with the headlight.
-
Raise the motorcycle with a lift stand.
-
Remove the front wheel.
-
Remove the fork legs. (0
-
Remove front fender. (0
-
Remove the lower triple clamp.
Main work
-
Remove lower bearing ring
Tool bracket (58429089000)
Pressing tool (58429092000)
-
Press the new bearing ring up to the stop with special
tool Ci).
Tool bracket (58429089000)
Pressing tool (58429091000)
6 FORK, TRIPLE CLAMP
(0 p. 42)
(0 p. 42)
(0 p. 13)
(� p. 113)
(� p. 13)
(0 p. 121)
p. 1 7)
p. 111)
(0 p. 37)
O 8.
with special tool
(0 p. 359)
(� p. 359)
(!!J p. 359)
(10 p. 359)
41