Installing The Primary Gear; Installing The Force Pump - Husqvarna FE 350 2016 Repair Manual

18 ENGINE
18.5.9
18.5.10
232

Installing the primary gear

Installing the force pump

0-
-
Position primary gear
✓ The wide tooth of the primary gear engages in the wide
recess of the crankshaft.
f)
✓ Markings and G) are aligned.
-
Set the crankshaft to top dead center and lock it with
screw@}.
-
Mount and tighten nut (D.
Guideline
Nut, primary M18LHx1.5
gear
-
Oil the oil pump shaft, internal rotor and external rotor before
assembly.
O.
-
Position force pump
Info
The rounded side of the force pump faces the engine
case.
8
-
Mount oil pump shaft
-
Mount pin (D.
-
Position the oil pump cover.
f)
✓ Marking faces upward.
-
Mount and tighten screws
Guideline
Screw, oil pump M5
cover
C,.
-
Insert pin
Position oil pump gear wheel 0).
-
Mount washer @.
@).
-
Mount lock ring
-
Crank the oil pump gear wheel and ensure that it can move
easily.
100 Nm (73.8 lbf ft)
Loctite ®
from below.
C,.
6 Nm (4.4 lbf ft)
®
Loctite
243
™
41
243
™