Husqvarna FE 350 2016 Repair Manual page 139

Using a suitable tool, press bearing
inside to the outside.
0-
Remove spacing tube
Using a suitable tool, press bearing (D out from the
inside to the outside.
Check spacer washer @ for damage and wear.
If the spacer washer is damaged or worn:
Replace the spacer washer.
Position spacer washer @.
Press new bearing (D all the way in from the outside to
the inside.
Info
Only press the bearing in via the outer ring oth­
erwise the bearing will be damaged when it is
pressed in.
-
Clean, grease, and mount spacing tube
I Long-life grease (� p. 354)
C,
Press new bearing all the way in from the outside to
the inside.
Info
Only press the bearing in via the outer ring oth­
erwise the bearing will be damaged when it is
pressed in.
-
Grease new shaft seal ring
flush.
14 WHEELS
C,
out from the
0.
@)
and press it in until it is
137