Husqvarna FE 350 2016 Repair Manual page 20

6 FORK, TRIPLE CLAMP
18
Info
The compression damping is located in left fork
leg COMP (white adjusting screw). The rebound
damping is located in right fork leg REB (red adjusting
screw).
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
must be flush with the upper edge of the upper triple
clamp.
(FE EU/AU, FE 350 US)
8.
-
Tighten screws
Guideline
Screw, top triple
clamp
-
Tighten screws (D .
Guideline
Screw, bottom
triple clamp
(FE 350 SUS)
@.
Tighten screws
Guideline
Screw, top triple
clamp
-
Tighten screws (D .
Guideline
Screw, bottom
triple clamp
-
Position the brake caliper, and mount and tighten screws
with the washers.
Guideline
Screw, front MS
brake caliper
-
Mount the cable tie(s).
-
Position the brake line, wiring harness, and clamp. Mount and
0.
tighten screws
Finishing work
-
Install the front wheel. (llt!l
-
Install the headlight mask with the headlight.
-
Check the headlight setting.
MS 17 Nm (12.5 lbf ft)
MS 15 Nm (11.1 lbf ft)
MS 17 Nm (12.5 lbf ft)
MS 15 Nm (11.1 lbf ft)
25 Nm (18.4 lbf ft)
®
Loctite
p. 122)
(llt!J p. 114)
(llt!J p. 169)
C,
243
™
..