Table of Contents
Advertisement
Main work
-
Check the wheel bearing for damage and wear.
If the wheel bearing is damaged or worn:
Change the rear wheel bearing.
-
Clean and grease shaft seal rings
of the spacers.
I
Long-life grease
(I!!;,!
p. 354)
-
Insert the spacers.
(FE EU/ AU, FE 350 US)
Clean and grease the wheel spindle.
I Long-life grease
(llill
-
Position the rear wheel and insert wheel spindle
-
Mount the chain.
✓ The brake linings are correctly positioned.
-
Position chain adjuster@). Mount nut
tighten it yet.
-
Make sure that chain adjusters
0.
adjusting screws
-
Check the chain tension.
C,.
-
Tighten nut
Guideline
Info
The wide adjustment range of the chain adjusters
(32 mm (1 .26 in)) enables different secondary
ratios with the same chain length.
Chain adjusters
-
Operate the foot brake lever repeatedly until the brake
linings are in contact with the brake disc and there is a
pressure point.
(FE 350 SUS)
-
Clean and grease the wheel spindle.
I Long-life grease
(I!!;,!
-
Position the rear wheel and insert wheel spindle
-
Mount the chain.
✓ The brake linings are correctly positioned.
(I!!;,!
p. 136)
O
and contact surface
p. 354)
8.
C,,
but do not
(s)
are fitted correctly on
(0
p. 129)
M20x1.5
80 Nm (59 lbf ft)
(s)
can be turned by 180
.
°
p. 354)
8-
14 WHEELS
6)
127
Advertisement
Table of Contents
