HP Integrity rx2620 Upgrade
System Hardware Component Upgrade Instructions
Figure 1-27 VGA and DB9 Mechanical Cover Locations
VGA cover
Step 4. Unscrew the six backplane system board mounting screws that connect the system board to the
rear of the system chassis.
Figure 1-28 Remove System Board Mounting Screws
Step 5. Disconnect all cables that are connected to the system board. To help with re-assembly, make note
of which cables were connected to which connector.
NOTE
Step 6. Unscrew the system board mounting screw. A screw symbol is adjacent to the mounting screw.
40
Rear of chassis
To access the three power cables near the PCI cage, you must lift up the connector
bridge for the PCI cage fan.
DB9 cover
Rear of chassis
Chapter 1