Table of Contents
Advertisement
If you need to install host adapters, see
procedure asks you to replace the failed host adapter, simply install the new host adapter instead.
M
Install and Cable the Hardware
Unpack, place, and level the storage array.
1
For instructions, see the Sun StorEdge 6130 Array Getting Started Guide or the Sun StorEdge online
documentation. For a list of array documentation, see
(Optional) Install the Fibre Channel (FC) switch for the storage array if you do not have a switch
2
installed.
For the procedure about how to install an FC switch, see the documentation that shipped with your
FC switch hardware.
3
Connect the nodes to the service processor panel.
(SAN Configuration) Connect the FC switches to the service processor panel.
I
(Direct-Attached Configuration) Connect each node to the host ports on the array.
I
For instructions, see the Sun StorEdge 6130 Array Getting Started Guide or the Sun StorEdge online
documentation.
Install the storage array.
4
For instructions, see the Sun StorEdge 6130 Array Getting Started Guide or the Sun StorEdge online
documentation.
Power on the storage array and the nodes.
5
For instructions, see the Sun StorEdge 6130 Array Getting Started Guide or the Sun StorEdge online
documentation.
M
Install the Solaris Operating System and Configure Multipathing
1
On all nodes, install the Solaris operating system and apply the required Solaris patches for Sun
Cluster software and storage array support.
For the procedure about how to install the Solaris operating environment, see "How to Install Solaris
Software" in Sun Cluster Software Installation Guide for Solaris OS.
If you are using Solaris OS software version 8 or version 9, install any required patches or software for
2
Sun StorEdge Traffic Manager software support to nodes and enable multipathing.
For the procedure about how to install the Sun StorEdge Traffic Manager software, see "How to
Install Sun Multipathing Software" in Sun Cluster Software Installation Guide for Solaris OS.
Chapter 2 • Installing and Configuring a Sun StorEdge 6130 Array
"How to Replace a Host Adapter" on page
Table
P–2.
Installing Storage Arrays
27. When this
15
Advertisement
Table of Contents
