How To Switch Led Display - EBARA EV-A Series Instruction Manual

5.2 How to switch LED display

Pump conditions and control settings can be checked on the LED display. Display shows 4 digits and
the first letter from the left is group code.
１） How to switch display
①Press ESC button, switches LED display
LED display code
③Running data monitor
(It only shows this function)
２） Group Code
Group Code
d000
b000
３） Contents of LED display
LED display code
d001
d002
d016
d017
d080
d081 – d086
PM10U
Group code
switches LED display code
d000
②Press ESC button,
changes LED display
④Press Up & Down button,
changes LED display
d000 d016
1585.
LED display
Monitors run data
Inverter setting
Display data
Run frequency
Secondary current
Total run hour
Total electrified hour
Error count monitor
Error monitor
LED Display
ESC Switch
UP Switch
DOWN Switch
⑤Press SET button
shows display data
Note）When the pump turns on, LED display shows run hour.
How to control
Only this group code(d) can be switched
This group code (b) can not be controlled
Unit
Monitor lamp (Hz) lights up when it is
Hz
displayed.
Monitor lamp (A) lights up when it is
A
displayed.
Data range
hrs
*1 0.0 – 9999.
*2 1000 – 9999
hrs
*3 「100 - 「999
*4 0. – 9999.
Time
*5 1000 - 6553
Last 6 errors available.
-
See P.47 how to use LED monitor section
- indicated when there is no error
⑥Press SET button again,
switches LED display
Note
Content
Indicated by hour
Indicated by 10 hr
Indicated by 1000 hr
Indicated by time
Indicated by 10 time
EBARA
P.31
SET Switch
CORPORATION