Operation Panel - EBARA EV-A Series Instruction Manual

There are four different modes to run and stop the pump, "Direct power input", "Operation by operation-
panel", "Operation by external signal" and "Operation by the handheld controller".
If "Direct power input" is selected, set driving connector, that is standard accessory, onto "I/O connector
(CN2)".

5.1 Operation Panel

Running status can be checked by LED display on operation-panel.
(8) LED Display
(7) LOCAL/REMOTE Lamp
(9) RUN Switch
(11) ESC Switch
(12) UP Switch
(13) DOWN Switch
PM10U
5. OPERATION PANEL
Fig. 5.1 Operation panel
Operation panel
(1)POWER Lamp
(4) RUN Lamp
(2)ALARM Lamp
(5)Monitor Lamp(Hz)
(3)PROGRAM Lamp
(6) Monitor Lamp(A)
(10) STOP/RESET Switch
(14) SET Switch
I/O Connector
CN2
Main switch
Power connector
CN1
Fig. 5.2 Pump operation side
EBARA
CORPORATION
P.29