SMART Embedded Computing MVME2500 Installation & Use Manual page 39

Installation Procedure
1. Attach an ESD strap to your wrist. Attach the other end of the strap to an electrical
ground. Make sure that it is securely fastened throughout the procedure.
2. Remove VME filler panels from the VME enclosures, as appropriate.
3. Install the top and bottom edge of the board into the guides of the chassis.
4. Ensure that the levers of the two injector/ejectors are in the outward position.
5. Slide the board into the chassis until resistance is felt.
6. Simultaneously move the injector/ejector levers in an inward direction.
7. Verify that the board is properly seated and secure it to the chassis using the two
screws located adjacent to the injector/ejector levers.
8. Connect the appropriate cables to the board.
Removal Procedure
1. Turn off the power.
2. Disconnect all the cables.
3. Press the red locking tabs (IEEE handles only) to extract the board.
4. Loosen and remove the screws located adjacent to the injector/ejector levers that
securing board to the chassis.
5. Move the injector/ejector levers in outward direction.
6. Hold top and bottom edges of the board and exert minimal force when pulling the board
from the chassis to prevent pin damage.
7. Carefully remove the board from the chassis and store the board in anti-static
envelope.
MVME2500 Installation and Use (6806800L01S)
Hardware Preparation and Installation
39