Setting Up Afterhours; Ending Afterhours - Lutron Electronics GRAFIK Eye QSGRN-6PCE Installation And Operation Manual

Afterhours

Setting Up Afterhours

Main menu 1. Enter programming mode.
2. Use the Master buttons to highlight "Timeclock", and press
Timeclock
Timeclock
the OK button to accept.
Scene setup
3. Use the Master buttons to highlight "Afterhours setup", and
press the OK button to accept.
4. Use the Master buttons to select the desired Afterhours mode,
Timeclock
and press the OK button to accept.
5. (If the Afterhours mode was set to "Enabled")
Holiday
Use the Master buttons to highlight the desired values for
Afterhours setup
Flash count, Delay time, Warn time, and Afterhours scene.
Press the OK button to accept each setting. The info screen
will confirm that your Afterhours settings have been saved.
Afterhours
6. Exit programming mode.
Enabled
Warn time
5 minutes
Flash count
3
Delay time
Afterhours
15 minutes
®
1
Saved
Scene 5
2 3 4 5 6
GRAFIK Eye QS Control Unit Installation and Operation Guide 58
®
OK

Ending Afterhours

Once activated, the Afterhours feature can
be overridden at any time and ended through
the programming menu.
1. Enter programming
mode.
End afterhours
2. Use the Master
buttons to highlight
"Timeclock", and
press the OK button
to accept.
3. Use the Master
buttons to highlight
"End Afterhours", and
press the OK button
to accept. The info
screen will confirm
that afterhours mode
is ended.
4. Exit programming
mode.
Master
buttons
OK
button