Table of Contents
Advertisement
Adjusting Window Treatment Settings
Preset Adjustment: Simple Method
1. Use the raise and lower buttons on the
shade button group to set all electronic
drive units (EDUs) of the window
treatments to the desired preset levels.
2. Press and hold the middle button on the
shade button group for 5 seconds to
save the EDU preset positions. The LED
9
10
3
1
2
11
next to the button will flash and then light
continuously, indicating the preset has
been stored.
Note: Once EDU presets have been
assigned to buttons on a shade
button group, those presets are
accessible for an EDU only using
the shade button group it is
assigned to, and a shade button
group can access preset levels only
for those EDUs assigned to it.
®
Preset Adjustment: Advanced Method
• The advanced method for adjusting
presets is needed only if you wish to
have the window treatments assigned to
the shade button group set at different
positions in the preset. If, however, you
wish all the window treatments in the
group to be lined up with one another in
the preset, you should use the Simple
Method at left.
• Entering Assignment mode will cause
5
13
6
15
8
16
4
12
14
7
the window treatments to move between
their open and close limits. Verify that
the open and close limits have been set
correctly .
1. On the shade button group whose
preset you wish to adjust, press and
hold simultaneously the top and bottom
buttons. The LEDs next to the buttons
will flash. EDUs for the assigned window
treatments will move to their closed
limits, and EDUs for unassigned window
treatments will move to their open limits.
2. Press and release the middle button on
that shade button group. The adjacent
LED will blink rapidly. EDUs for assigned
window treatments will automatically
move to their current preset settings.
(for Wired and Wireless Sivoia
1
9
2
10
3
11
4
12
5
13
9-16
1-8
OK
GRAFIK Eye
QS Control Unit Installation and Operation Guide 47
®
QS Window Treatments)
®
3. Use the raise and lower buttons to move
all EDUs for assigned window treatments
together to the desired preset setting.
4. To move an EDU individually to its
desired preset setting, select the EDU
using the top button on the shade button
group. Each time you press and release
the top button, a different EDU that is
6
14
7
15
8
16
assigned to that shade button group will
open and close in an 200 mm range.
Press repeatedly until the EDU for the
9-16
1-8
window treatment you wish to adjust
moves. Adjust that EDU to the desired
height using the raise and lower buttons.
Repeat this step for all assigned EDUs.
5. Once you are satisfied that all the
assigned EDUs are set to the positions
you want to assign as the preset, press
and hold the middle button on the shade
button group for 5 seconds. The preset
will be saved.
6. Press and hold simultaneously the top
and bottom buttons on the shade button
group for 5 seconds to exit to normal
mode. The LEDs next to the buttons will
stop flashing.
OK
Advertisement
Table of Contents
Troubleshooting
