Setting Load Types - Lutron Electronics GRAFIK Eye QS Quick Installation And Operation Manual

Zone Setup
(continued)

Setting Load Types

Fixture load type
Incandescent
MLV (magnetic low-voltage)
ELV (electronic low-voltage)
Hi-Lume/Eco-10
0-10 V
Non-dim lighting loads
Neon/Cold cathode
Tu-Wire
Advance Mark X
EcoSystem
DMX
RGB/CMY DMX
EcoSystem switching
(e.g., XPJ)
Cree LR4/LR6 LED
LED
EcoSystem
DMX
RGB/CMY DMX
EcoSystem switching
(e.g., XPJ)
®
Direct control via
GRAFIK Eye QS
control unit
To
EcoSystem
link
LUTRON
Choose this load type from the menu
on the GRAFIK Eye QS control unit:
Incandescent
LUTRON
MLV
—
—
—
Non-dim
Neon, CC
Tu-Wire
Tu-Wire
Digital load
—
—
Non-dim digital
Cree LR4/LR6 LED
Incandescent*
Digital load
—
—
Non-dim digital
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with EcoSystem Control Unit Quick Installation and Operation Guide 14
Control via
power module or
interface
Power
module or
LUTRON
interface
LUTRON
Power module
Power module
Power module
Fluorescent module
Fluorescent module
Non-dim
Neon, CC
Tu-Wire
Tu-Wire
—
DMX
RGB/CMY DMX
—
Fluorescent module
Power Module
—
DMX
RGB/CMY DMX
—
Load Type Notes
• All electronic low-voltage
(ELV) lighting used with an
interface must be rated for reverse
phase control dimming. Before
installing an ELV light source,
verify with the manufacturer that
their transformer can be dimmed.
When dimming, an ELV interface
(such as the PHPM-PA-DV-WH)
must be used with the control
unit.
• For all DMX or RGB/CMY DMX
lighting, an external DMX interface
(such as the QSE-CI-DMX) must
be used with the control unit.
• Maximum total lighting load for
Lutron Tu-Wire and Advance Mark
X electronic dimming ballasts
(120 V~ only) must not exceed 6
A per zone or 16 A per unit.
For non-EcoSystem loads:
• Not all zones must be connected;
however, connected zones must
have a minimum load:
120 V~: 25 W
220 - 240 V~: 40 W
• Maximum zone loads:
120 V~: 800 W
220 - 240 V~: 1200 W
• Maximum total lighting load for
magnetic low-voltage (MLV) varies
by input voltage:
120 V~: 800 VA / 600 W
220 - 240 V~: 1200 VA / 960 W
Use incandescent load type unless otherwise
*
specified in the LED product selection tool
available at www.lutron.com/ledtool.