Daylight Sensor Setup - Lutron Electronics GRAFIK Eye QSGRN-6PCE Installation And Operation Manual

Daylight Sensor Setup

Lutron daylight sensors work with the GRAFIK Eye
light in the room changes.
Wired daylight sensors may be connected to a QS Sensor Module (QSM) in the QS system.
QS Link
LUTRON
LUTRON
GRAFIK Eye QS
®
control unit
Wireless Radio Powr Savr
LUTRON
first be associated with one of these devices to be recognized by a GRAFIK Eye
LUTRON
LUTRON
GRAFIK Eye QS
®
control unit
LUTRON
The following steps are required to program daylight sensors with a GRAFIK Eye
unit. Instructions for each step are on the pages that follow.
1. Connect wired sensors, or associate wireless sensors. LUTRON
2. Assign sensors to zones.
3. Calibrate the system to achieve the desired response to natural light.
Note: The Daylighting feature is not supported for the DMX load type.
LUTRON
®
QS Wireless control unit to automatically adjust electric light levels when natural
®
QS
Wired
Sensor Module
Daylight
(QSM)
Sensor
daylight sensors can be associated with a GRAFIK Eye
TM
Wireless
Daylight Sensor
LUTRON
Wired to QSM
Wired to QSM
LUTRON
Wired to Eco device
QS control unit or QSM. Wireless sensors must
®
Wired to Eco device
QS wireless system.
®
LUTRON
QS Link
Wireless to Gra k Eye
LUTRON
GRAFIK Eye QS
Sensor Module
®
Wireless to Gra k Eye
control unit
QS control
®
Wireless to QSM
Wireless to QSM
GRAFIK Eye QS Control Unit Installation and Operation Guide 33
®
Wireless
QS
Daylight Sensor
(QSM)
Wired
Wire
Wire