Enabling/Disabling The Ir Receiver - Lutron Electronics GRAFIK Eye QSGRN-6PCE Installation And Operation Manual

IR Setup
Enabling/disabling the IR receiver on the GRAFIK Eye
Note: These steps will also enable or disable the IR terminals on the
Main menu
1. Enter programming mode.
Wireless Mode
2. Use the Master buttons to highlight "IR Setup" and press the OK button to
IR Setup
accept
3. Use the Master buttons to highlight "Integral IR" and press the OK button to
accept.
IR menu
4. Use the Master buttons to highlight either "Enabled" or "Disabled" and press
the OK button to accept. The info screen will confirm that your settings have
Integral IR
Timeclock
been saved.
Programming
5. Exit programming mode.
Integral IR
Enabled
Saved
Saved
®
GRAFIK Eye QS control unit.
1 9
®
QS control unit:
®
2 10 3 11 4 12 5 13 6 14
GRAFIK Eye QS Control Unit Installation and Operation Guide 41
®
7 15 8 16
9-16
1-8
OK
Master
buttons
OK
button