Associating Through A Qs Sensor Module - Lutron Electronics GRAFIK Eye QSGRN-6PCE Installation And Operation Manual

Pico Wireless Control Setup
®
Associating the Pico wireless control through a QS Sensor Module (QSM):
®
(for wired or wireless enabled GRAFIK Eye
1. Press and hold the Program button on the QSM for 3 seconds
QSM
to enter programming mode. There will be 1 audible beep
Programming
and the Status LED will begin flashing. The info screen on the
GRAFIK Eye
programming mode.
2. Press and hold the bottom button on the Pico
QSM
for 6 seconds. There will be 3 audible beeps from the QSM to
verify association.
Change type?
3. Press and hold the Program button on the QSM for 3 seconds
to exit programming mode.
Press OK
4. On the Pico
and bottom (off) buttons for 3 seconds, until the LEDs on the
Change type?
GRAFIK Eye
beeps 1 time. Press the OK button on the GRAFIK Eye
control unit to select the desired operation mode for the Pico
Zone
wireless control.
5a. To assign the Pico
OR
the Master buttons to select "Zone" and press the OK button
to accept. Use the zone raise/lower buttons for a zone to select
Change type?
a desired preset level, and then press the zone raise and lower
buttons simultaneously for 1 second (until the zone LEDs flash
Scene
at the programmed preset level). Repeat for all zones you wish
to control with the Pico
OR
5b. To assign the Pico
the Master buttons to select "Scene" and press the OK button
Saved
Saved
to accept. Press and hold the top scene button on the GRAFIK
Eye
6. On the Pico
bottom buttons for 3 seconds until the LEDs on the GRAFIK
Eye
®
QS control units)
®
QS control unit will display that the QSM is in
®
wireless control, press and hold the top (on)
®
QS control unit begin to flash and the QSM
®
wireless control as a zone controller, use
®
wireless control.
®
wireless control as a scene controller, use
®
QS control unit for 3 seconds (until the scene LEDs flash).
®
wireless control, press and hold the top and
®
control unit stop flashing and the QSM beeps 1 time.
®
QS Sensor Module
(QSM)
wireless control
®
QS
®
®
GRAFIK Eye QS Control Unit Installation and Operation Guide 39
®
Program button
Top/On
button
Bottom/Off
button
Pico
®
Wireless
Control