Setting Up Afterhours; Ending Afterhours - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Afterhours (continued)

Setting Up Afterhours

1. Enter programming mode.
Main menu
2. Use the Master buttons to highlight "Timeclock," and press
Timeclock
Timeclock
the "OK" button to accept.
Scene setup
3. Use the Master buttons to highlight "Afterhours setup," and
press the "OK" button to accept.
4. Use the Master buttons to select the desired "Afterhours"
Timeclock
mode, and press the "OK" button to accept.
5. (If the "Afterhours" mode was set to "Enabled")
Holiday
Use the Master buttons to highlight the desired values for
Afterhours setup
Flash count, Delay to off, Delay to flash, and Afterhours scene.
Press the "OK" button to accept each setting. The info screen
will confirm that your Afterhours settings have been saved.
Afterhours
6. Exit programming mode.
Enabled
Delay to flash
minutes
45
Flash count
3
Delay to off
Afterhours
minutes
5
®
Saved
Scene off

Ending Afterhours

Once activated, the Afterhours feature can
be overridden at any time and ended through
the programming menu.
GRAFIK Eye QS Control Unit Installation and Operation Guide 60
®
OK
1. Enter programming
mode.
End afterhours
2. Use the Master
buttons to highlight
"Timeclock," and
press the "OK" button
to accept.
3. Use the Master
buttons to highlight
"End Afterhours," and
press the "OK" button
to accept. The info
screen will confirm
that "Afterhours" mode
is ended.
4. Exit programming
mode.
Master
buttons
"OK"
button