Setting Save Mode; Save Mode Settings; Quick Scene Programming; Save By Ok Mode - Lutron Electronics GRAFIK Eye QSGRN-6PCE Installation And Operation Manual

Setting Save Mode

The Save Mode of the GRAFIK Eye
scene programming on and off, or to disable the use of zone and/or scene buttons
for specific applications.
Main menu

Save Mode Settings

Save by OK (default): Quick scene programming mode; zone
Scene setup
adjustments are temporary until the OK button is pressed to
Save mode
confirm the selection.
Save always: Automatically save changes made to lighting
levels or fade time to Off (Master button changes are
Save mode
temporary).
Save never: Do not save any temporary changes to lighting
Save always levels or fade time.
Four scenes (typically used for rented spaces): Zone raise/
lower buttons are disabled. Master raise/lower buttons,
wallstations, and IR receiver are still enabled for adjustment of
light level, but these changes are not saved.
Button disable (typically used in a public space): Only the
Saved
timeclock button, IR receiver, and wallstations can be used to
make temporary changes.
Changing the Save Mode
1. Enter programming mode.
2. Use the Master buttons to highlight "Save mode" and press
the OK button to accept.
3. Use the Master buttons to highlight the desired save mode.
The save modes are listed and explained below.
4. Press the OK button to accept. The info screen will confirm
that your save mode has been saved.
5. Exit programming mode.
®
QS control unit can be adjusted to turn quick
®
1 2 3 4 5 6
1. Press the button for the scene you want
2. Use the zone raise/lower buttons to set
3. Set the fade time to the desired length
4. The info screen will confirm that the new
• Using the Master buttons to raise or
• To set a zone to unaffected (---), press
GRAFIK Eye QS Control Unit Installation and Operation Guide 23
®
OK
Zone raise/lower buttons

Quick Scene Programming:

Save by OK Mode

By default, the GRAFIK Eye
unit is in "Save by OK" mode, which
allows you to quickly set scenes without
entering program mode.
to set; its LED will light and the lights will
go to the current settings.
all lights to the desired levels. Press the
OK button to select.
using the Master buttons, and press the
OK button to save.
scene settings have been saved.
Notes
lower lighting settings is still temporary.
and hold the zone lower button for 6
seconds after the zone has gone to 0%
light level.
Master
buttons
OK
button
QS control
®