How To Set The Model - Epson C8 Series Manipulator Manual

Setup & Operation 2. Specifications

2.7 How to Set the Model

The Manipulator for your system has been set before shipment.
■ When you need to change the setting of the Manipulator model, be sure to set the
Manipulator model properly.
result in abnormal or no operation of the Manipulator and/or cause safety
CAUTION
problems.
NOTE
If the custom specifications number (MT***) is described on MODEL of the signature label

(S/N label), the Manipulator has custom specifications. (A label with only the custom
specifications number may be attached depending on shipment time).
The custom specifications may require a different configuration procedure; check the
custom specifications number (MT***) and contact the supplier of your region if necessary.
The Manipulator model can be set from software.
Refer to the chapter Robot Configuration in the EPSON RC+ User's Guide.
28
Improper setting of the Manipulator model may
C8 Rev.13