How To Set The Model - Epson LS3-401 series Manipulator Manual

Setup & Operation 2. Specifications

2.5 How to Set the Model

The Manipulator model for your system has been set before shipment from the factory.
It is normally not required to change the model when you receive your system.
■ When you need to change the setting of the Manipulator model, be sure to set the
Manipulator model properly. Improper setting of the Manipulator model may
result in abnormal or no operation of the Manipulator and/or cause safety
CAUTION
problems.
NOTE If an MT label is attached to the rear of a Manipulator, the Manipulator has custom

specifications.
procedure; check the custom specifications number described on the MT label and contact
us when necessary.
The Manipulator model can be set from software.
Refer to the chapter Robot Configuration in the EPSON RC+ User's Guide.
28
The custom specifications may require a different configuration
LS Rev.10