Table of Contents
Advertisement
(6) Select the series name of the Manipulator in the [Series] box.
(7) Select the robot model in the [Model] box.
(8) Click the <OK> button. The Controller will be restarted.
5.6 Setting the Cartesian (Rectangular) Range in the XY Coordinate
System of the Manipulator
The Cartesian (rectangular) range in the XY coordinate system of the Manipulator is
specified by the limited Manipulator operation area and the XYLIM setting.
The limited Manipulator operation area is defined so that the end effector does not interfere
with the rear side of the Manipulator. The XYLIM setting that you can determines the
upper and lower limits of the X and Y coordinates.
The limited Manipulator operation area and the XYLIM setting apply only to the software.
Therefore, these settings do not change the physical range. The maximum physical range
is based on the position of the mechanical stops.
These settings are disabled during a joint jogging operation. Therefore, be careful not to
allow the end effector to collide with the Manipulator or peripheral equipment.
The method for changing the XYLIM setting varies with the software used.
Set the XYLIM setting in [Tools]-[Robot manager]-[XYZ Limits] panel.
EPSON
RC+
You may also execute the XYLim command from the [Command Window].
C8 Rev.13
according to the format of the currently installed motor driver. When [Dry run] is used,
all the Manipulators of the series selected in Step 6 will be displayed.
Setup & Operation 5. Motion Range
Available robots will be displayed
73
Advertisement
Table of Contents
