End Effectors; Attaching An End Effector; Attaching Camera And Air Valves - Epson C8 Series Manipulator Manual

Setup & Operation 4. End Effectors

4. End Effectors

4.1 Attaching an End Effector

Create an end effector for your Manipulator. Flange dimensions of the wrist attached to
the end of Arm #6 is as below.
■ If you use an end effector equipped with a gripper or chuck, connect wires and/or
pneumatic tubes properly so that the gripper does not release the work piece
when the power to the robot system is turned OFF. Improper connection of the
wires and/or pneumatic tubes may damage the robot system and/or work piece
as the work piece is released when the Emergency Stop switch is pressed.
CAUTION
I/O outputs are configured at the factory so that they are automatically shut off (0)
by power disconnection, the Emergency Stop switch, or the safety features of the
robot system.
Wrist Flange
Arm #6
Attach an end effector to the end of the Arm #6 using the M5 bolts.
Layouts
When you operate the Manipulator with an end effector, the end effector may interfere with
the Manipulator body depending on the outer diameter of the end effector, the size of the
work piece, or the position of the arms. When designing your system layout, pay close
attention to the interference area of the end effector.
Compatibility with ISO flange:
To install the end effector whose mounting dimensions are designed for the ISO flange, we
provide the optional C8 ISO flange (J6).
Options.

4.2 Attaching Camera and Air Valves

Decks are equipped to Arms #3 and #5 to enable the easy installation of air valve.
To mount the camera, the camera plate unit is necessary.
We provide the optional Camera Plate Unit. For details, refer to Setup & Operation: 6.
Options.
46
For details, refer to Setup & Operation: 6.
C8 Rev.13