Epson C8 Series Manipulator Manual page 126

Maintenance 3. Covers
Installation Install the Arm #3 maintenance cover to the Manipulator.
(S, C models)
Installation 1. Install the spacers to the holes on the gasket.
model
(P )
2. Apply the liquid gasket to the Arm #3 maintenance gasket.
NOTE
After applying the liquid gasket, leave the gasket until the liquid gasket becomes solid

and the gasket is fixed.
3. Install the Arm #3 maintenance cover to the Manipulator.
Be careful not to get the gasket and cables caught between the cover and the
NOTE

Manipulator.
Replace the gasket if there are flaws or deteriorations.
112
Cross recessed truss head small screws: 4-M4×8
Tightening Torque: 0.9 ± 0.1 N·m
Be careful not to get the cables caught between the cover and the Manipulator.
(4 places)
Install the Arm #3 maintenance gasket to the Arm #3 maintenance cover.
(See the figure for gasket applying points)
Hexagon socket head cap bolts: 4-M4×10
Tightening torque: 4.0 ± 0.2 N·m
Gasket applying point (×4)
Arm #3 maintenance cover
Arm #3 maintenance gasket
Spacer (×4)
C8 Rev.13