Table of Contents
Advertisement
Related Information
Oracle Solaris OS documentation
■
"Configure the Preinstalled OS" on page 82
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 82
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 84
■
Assign a Static IP Address to the NET MGT Port
If you plan to connect to the SP through its NET MGT port, the SP must have a valid IP
address.
By default, the server is configured to obtain an IP address from DHCP services in your
network. If the network your server is connected to does not support DHCP for IP addressing,
perform this procedure.
To configure the server to support DHCP, refer to the Oracle ILOM documentation.
Note -
This procedure sets a static ipv4 address. If you are using an ipv6 address or a dual-stack (IPv4
and IPv6) network configuration, refer to "Modify Default Connectivity Configuration in
Oracle ILOM Administrator's Guide for Configuration and Maintenance.
Connect to the Oracle ILOM on the SP using the SER MGT port.
1.
If you are not already connected through the SER MGT port, perform steps as needed in
"Connect a Terminal or Emulator to the SER MGT Port" on page
Set the SP to accept a static IP address.
2.
->set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
3.
Set the IP address for the SP.
->set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to 'service-processor-IPaddr'
4.
Set the IP address for the SP gateway.
-> set /SP/network pendingipgateway=gateway-IPaddr
Set 'pendingipgateway' to 'gateway-IPaddr'
Assign a Static IP Address to the NET MGT Port
77.
Powering On the Server for the First Time
87
Advertisement
Table of Contents
