Assign A Static Ip Address To The Net Mgt Port - Oracle SPARC T7-4 Installation Manual

Assign a Static IP Address to the NET MGT Port

->
Related Information
"Rear Panel Components" on page 15
■
"Cabling Requirements" on page 51
■
SPARC T7 Series Servers Administration Guide
■
Oracle ILOM documentation
■
Assign a Static IP Address to the NET MGT Port
If you plan to connect to the SP through its NET MGT port, the SP must have a valid IP
address.
By default, the server is configured to obtain an IP address from DHCP services in your
network. If the network your server is connected to does not support DHCP for IP addressing,
perform this procedure.
Note -
Set the SPM to accept a static IP address.
1.
-> set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
2. Set the IP address for the SP.
Oracle ILOM is shipped with IPv4 DHCP and IPv6 stateless default network settings.
To change the default IPv4 DHCP property and set property values for a
■
static IPv4 address, type IPv4_address.
To change the default IPv6 DHCP property and set property values for a
■
static IPv6 address, type IPv6_address.
This setting configures the host to stop at the ok prompt instead of automatically booting
the preinstalled OS.
-> set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to ' service-processor-IPaddr'
For more information about the administration tasks such as modifying default network
connectivity settings, refer to the Oracle ILOM documentation.
78 SPARC T7-4 Server Installation Guide • March 2017
To configure the server to support DHCP, refer to the Oracle ILOM documentation.