Identifying Ports - Oracle SPARC S7-2L Installation Manual

Identifying Ports

Netmask
■
IP address for the SP
■
Gateway IP address
■
At a minimum, you must connect cables to these ports before powering-on the server for the
first time:
SP SER MGT port
■
SP NET MGT port (if you plan to use this port as soon as it is available)
■
At least one system on-board Ethernet network port
■
Power cables to the power supply inlet ports
■
Related Information
"Connect the SER MGT Cable" on page 67
■
"Connect the NET MGT Cable" on page 68
■
"Connect Ethernet Network Cables" on page 70
■
"Prepare the Power Cords" on page 76
■
Identifying Ports
These topics provide the pin descriptions of the ports.
"Rear Panel Components (Installation)" on page 20
■
"USB Ports" on page 61
■
"SER MGT Port" on page 61
■
"NET MGT Port" on page 63
■
"10 Gigabit Ethernet Ports" on page 64
■
"SAS Ports" on page 65
■
Related Information
"Server Overview" on page 12
■
"Front Panel Components With Eight-Drive Backplane (Installation)" on page 14
■
"Rear Panel Components (Installation)" on page 20
■
"Cabling Requirements" on page 59
■
60 SPARC S7-2L Server Installation Guide • June 2017