Assign A Static Ip Address To The Net Mgt Port - Oracle SPARC T8-1 Installation Manual

Assign a Static IP Address to the NET MGT Port

Parameter
IPv6?
Security Policy
Confirm
Name Service
NFSv4 Domain Name
Time Zone (Continent)
Time Zone (Country or Region)
Time Zone
Date and Time
root Password
Related Information
Oracle Solaris OS documentation
■
"Configure the Preinstalled OS" on page 63
■
"Reach a State to Install a Fresh OS (Oracle ILOM CLI)" on page 63
■
"Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)" on page 65
■
Assign a Static IP Address to the NET MGT Port
If you plan to connect to the SP through its NET MGT port, the SP must have a valid IP
address.
By default, the server is configured to obtain an IP address from DHCP services in your
network. If the network your server is connected to does not support DHCP for IP addressing,
perform this procedure.
Note -
1. Connect to the Oracle ILOM on the SP using the SER MGT port.
If you are not already connected through the SER MGT port, perform steps as needed in
"Connect Cables" on page
68 SPARC T8-1 Server Installation Guide • June 2019
Description
Specify whether or not to use IPv6. If you are not sure, select No to configure the Ethernet interface
for IPv4.
Select either standard UNIX security (No) or Kerberos Security (Yes). If you are not sure, select No.
Review the onscreen information and change it if needed. Otherwise, continue.
Select the name service according to your network environment.
If you select a name service other than None, you will be prompted for additional name service
configuration information.
Select the type of domain name configuration according to your environment. If you are not sure,
select Use the NFSv4 domain derived by the system.
Select your continent.
Select your country or region.
Select the time zone.
Accept the default date and time, or change the values.
Type the root password twice. This password is for the superuser account for the Oracle Solaris OS
on this server. This password is not the SP password.
To configure the server to support DHCP, refer to the Oracle ILOM documentation.
51.