Oracle SPARC S7-2L Installation Manual page 78

Connect a Terminal or Emulator to the SER MGT Port
Note -
emulator (PC or workstation) connected to the SP SER MGT port, you will not see system
messages.
4. (Optional) Connect an Ethernet cable between the server's NET MGT port and
the network to which future connections to the SP and host will be made.
Configure the system for the first time through the SER MGT port. After the initial
configuration, you can set up communication between the SP and host through this Ethernet
interface.
Connect an Ethernet cable between one of the server's NET ports and the
5.
network to which the server will communicate.
6. Connect the power cords to the power supplies and to separate power sources.
When the power cords are connected, the SP initializes and the power supply LEDs illuminate.
After a few minutes, the SP login prompt is displayed on the terminal device. At this time, the
host is not initialized or powered on.
78 SPARC S7-2L Server Installation Guide • June 2017
If you power on the server for the first time and do not have a terminal or terminal