Oracle SPARC S7-2L Installation Manual page 48

Hide thumbs Also See for SPARC S7-2L:

Table of Contents

Prepare the CMA for Installation

Note -

is shown in the following figures), and one cover with a single hinge.

Apply upward pressure to the outside edge of each hinge connector until the

hinge connector comes off the hinge [(panel 3).

Repeat

One at a time, position each round cable cover horizontally over the hinges,

and align the hinge connectors with the hinges.

Using your thumb, apply downward pressure on each hinge connector to

snap the hinge connector into place.

Swing the cable covers down and press down on the cable cover handle to

lock them into the closed position.

SPARC S7-2L Server Installation Guide • June 2017

The CMA has two sets of three cable covers, two covers with two hinges (one of which

Step 4a

and

Step 4b

to remove all three cable covers.

Table of Contents