Oracle SPARC S7-2L Installation Manual page 69

If your network uses a DHCP server to assign IP addresses, the DHCP server assigns an IP
address to this NET MGT port. With this IP address, you can connect to the SP using an SSH
connection. If your network does not use DHCP, this NET MGT port is not accessible until
you configure the network settings through the SER MGT port. For instructions, see
Static IP Address to the NET MGT Port" on page
1. Connect the SER MGT port to a terminal or computer first, if you are performing
the initial server configuration.
See "Connect the SER MGT Cable" on page
2. Connect a Category 5 (or better) RJ-45 cable from the NET MGT port to your
network switch or hub.
3. Connect other cables.
Related Information
"Connect Ethernet Network Cables" on page 70
■
"Assign a Static IP Address to the NET MGT Port" on page 87
■
87.
67.
Connect the NET MGT Cable
"Assign a
Connecting Cables 69