Restoring Works Settings - Lauda PROLINE P 5 C Operating Instructions Manual

7.8.5 Restoring works settings

Master
3x to
MNEnu
to 3x
PArA
dEF
3 seconds long
or
Command
All modules
Master
Command
Pump Menu
02/2022
dEF
If you would like to restore all the works settings except the control parameters
P1d
 call the works settings
dEF

°C
 Press longer than 3 seconds.
 The changeover is acknowledged with
 Proceed to the next menu until
 Press this key.
All default
only control par int
only control par ext
only miscellaneous
End T
set
Proline heating thermostat
and the probe calibrations
dEF
is displayed.
Works setting
 Open the device parameter menu via the soft
 With the cursor keys continue to:
 The window shown opposite appears.

 Under
T
fix
CAL
,
.
donE
.
End
appears.
key Menu .
Settings Works settings
 
Master and then only control para int
shown as a possible choice.
There are however various possibilities, which
can be selected with or
All modules Master, Command and all
connected modules are reset to the works
setting with All default .
.
is
51 / 123