Table of Contents
Advertisement
Command
LOG_IN_00_XXXX
LOG_IN_01
LOG_IN_02
LOG_IN_03
8.3.7 Error messages
Message
ERR_2
ERR_3
ERR_5
ERR_6
ERR_8
ERR_30
ERR_31
ERR_32
ERR_33
ERR_34
ERR_35
ERR_36
ERR_37
8.3.8 Driver software for LABVIEW®
An individual, easy-to-use control and automation software for operating the PROLINE device can be programmed
with the aid of the National Instruments program development tool LABVIEW
(http://sine.ni.com/apps/we/nioc.vp?cid=1381&lang=US).
In order to make program operation possible on the RS 232/485 interface, LAUDA provides drivers specially de-
signed for LABVIEW
02/2022
Read measuring point XXXX from data logger
(Reply: e. g. 020.00_021.23_030.50 set point temperature = 20.00 °C,
bath temperature = 21.23 °C, external temperature = 30.5 °C)
Read all measuring points from data logger
As a difference to the command "LOG_IN_00", a tabulator is used here as sepa-
rator instead of ,_' . The measuring points are separated by CR and LF. The end is
marked by CR LF CR LF.
Read starting time of the data logger
(Reply: e.g. 20_14_12_20 day 20, 14:12:20 o'clock)
Read acquisition interval from the data logger (Reply in seconds)
For "_" use also " " (blank character) is also admissible.
The equipment response is always in the fixed decimal format "XXX.XX" or for negative val-
ues "-XXX.XX" or " ERR_X". (RS 485 interface e.g. "A015_ XXX.XX" or "A015_-XXX.XX"
or "A015_ERR_X").
Explanation
Wrong input (e.g. buffer overflow)
Wrong command
Syntax error in value
Illegal value
Module resp. value not available
Programmer, all segments occupied
Set point not possible, analogue set point input ON
TiH ≤ TiL
external sensor missing
Analogue value not available
Automatic is selected
No set point input possible. Programmer is running or is pausing.
No start from programmer possible, analogue setpoint input is switched on.
®
which can be downloaded free of charge underFehler! Hyperlink-Referenz ungültig..
Proline heating thermostat
Explanation
®
97 / 123
Advertisement
Table of Contents
